Generac-power-systems 005324-1 Instrukcja Użytkownika Strona 1

STANDBY GENERATOROWNER'S MANUALThis manual should remain with the unit.A new standard of reliabilitySerial Number1.6L25kWModels: 005324-1005325-1

SPECIFICATIONSGENERATORType ... SynchronousRotor Insulation ...

COLD WEATHER KITFor cold climates, optional cold weather kit (part number 0F6148) is recommended. The kit includes:• Battery Warmer• 4” Junction Box

GENERATOR AC LEAD CONNECTIONSSee “Voltage Codes”. This generator may be rated at any one of three voltages, either single-phase or three-phase. The el

INSTALLATIONRefer to the separate “Installation Guide QT Product Line” supplied with the unit.PREPARATION BEFORE START-UPThe instructions in this sect

• Battery charger connection to 120 VAC.• Communication wires connected between transfer switch and generator (HTS only).• Unit secured to pad.STAR

GENERATOR CONTROL AND OPERATIONRefer to the appropriate control panel operator’s manual for this unit.OPERATING UNIT WITH MANUAL TRANSFER SWITCHIf the

MAINTENANCE PERFORMED BY SERVICE FACILITIES  Before working on the generator, ensure the fol-lowing:The AUTO/OFF/MANUAL switch is in the OFF positio

Figure 10.1 - Oil Dipstick and Oil Fill CapOIL FILL CAPOILDIPSTICKBATTERY FLUIDCheck battery electrolyte fluid based on the Maintenance Schedule. Flui

CHANGING ENGINE OILRefer to maintenance performed by service facilities for engine oil and filter change frequencies.Drain the oil while the engine is

MISCELLANEOUS MAINTENANCECLEANING THE GENERATORKeep the generator as clean and as dry as possible. Dirt and moisture that accumulates on internal gen-

Standby Generator SetsTable of ContentsSECTION PAGESAFETY RULES ... 1-1INTRODUCTION ...

SERVICE SCHEDULEThe following is a recommended maintenance schedule for small standby and residential generator sets. The established intervals in the

Maintenance Level 1 Level 2 Level 3 Level 4 Tasks Recom- Task Required Task Required Task Task mended Comp. to be done Comp. to be

Maintenance Level 1 Level 2 Level 3 Level 4 Tasks Recom- Task Required Task Required Task Task mended Comp. to be done Comp. to be

TROUBLESHOOTING GUIDEPROBLEM CAUSE CORRECTIONEngine won’t crank. 1. 15 amp fuse blown. 1. Replace fuse. 2. Loose or corroded or defective 2.

Standby Generator SetsNotes

Standby Generator SetsNotes

Standby Generator SetsNotes

Standby Generator SetsNotes

1 0F7135 1 BREAKER TRAY BACK/BOTTOM 2 0F7022 1 SUPPORT CONTROL PANEL SIDE RH 3 0F7021 1 SUPPORT CONTROL PANEL SIDE LH 4 0F7260 1 COVER CIRCUIT B

Study these SAFETY RULES carefully before install-ing, operating or servicing this equipment. Become familiar with this Owner’s Manual and with the un

ROT0RS BELOW MUST BE VERIFIED BY SERIAL NO. AND B.O.M. 1 0G2927 1 RTR-102-20.0AD1 CPL (2006) (FOR UNITS BUILT AFTER FEBRUARY 2007) 0G2827 1

COMPONENTS INCLUDED IN 0G3365E 1 0F1823A 1 ENCL HSB CONTROL PANEL 2 0F3078 1 COVER CONTROL PANEL 3 0F2606 1 HINGE CONTINUOUS H-PANEL 4 036

1 0F7211 1 SUPPORT RADIATOR LH SIDE 2 0G0760 1 VENTURI 16" DIA FAN 3 0F7210 1 SUPPORT RADIATOR RH SIDE 4 0E9837B 1 RADIATOR 1.6L CHY 5 0F0

1 0F3408B 1 BATTERY TRAY C1 CPL 2 0F3411 1 STRAP BATTERY RETAINMENT 3 025507 1 WASHER SHAKEPROOF EXT 7/16 STL 4 059980 1 SCREW HHC M10-1.5 X 2

1 0G0759 1 MOUNTING BASE 1.6L2 027482 2 WASHER SHAKEPROOF EXT 5/16 STL3 070936 2 DAMPENER VIBRATION4 070936C 2 VIB. ISO. 70-75 DURO5 039253 8 SCREW HH

• Before performing any maintenance on the gen-erator, disconnect its battery cables to prevent accidental start-up. Disconnect the cable from the bat

1 098290 1 ASM MOTOR STEPPER2 098941A 1 HOUSING GOVERNOR CONNECTOR3 098958A REF CONNECTOR INTERFACE ASSEMBLY4 098942A 1 COVER CONNECTOR HOUSING5 09822

1 0G0207 REF ENGINE GENERAC 1.6L NG 2 0G0834 1 ENGINE PLATE 1.6L 3 0G0820 REF HOUSING BLOWER MACHINED 1.6L 4 0E9747 1 STARTER 12 VOLT 5 0

1 026812 2 ELBOW 90D 3/4 NPT 2 075580 1 FLANGE FUEL INLET 3 0G1397 1 FUEL REGULATOR 1.6L REWORK 4 039253 2 SCREW HHC M8-1.25 X 20 G8.8 5 022

1 0F7003 (XX) 1 ROOF C1 CPL2 0F7004 (XX) 1 CORNER POST LH SIDE C1 CPL3 0F7008 (XX) 1 DOOR REAR C1 CPL4 0F7005 (XX) 1 CORNER POST RH SIDE C1 CPL5

1 0F7366 1 MUFFLER C1 2 0F7647 1 MUFFLER SADDLE 3 0F8095 1 PIPE EXHAUST OUTLET 4 0F7538 1 PIPE EXH INLET MUFLR SIDE 1.5L 5 0E3257 4 SCREW HWH

1-3INTRODUCTIONThank you for purchasing this model of the standby generator set product line.Every effort was expended to make sure that the informati

IDENTIFICATION RECORDDATA LABELEvery generator set has a DATA LABEL that contains important information pertinent to the generator. The data label, wh

Standby Generator SetsWarrantyPrinted in U.S.A.GENERAC POWER SYSTEMS STANDARD LIMITED WARRANTY FORHOME STANDBY/LIGHT COMMERCIAL PRODUCT 45kW AND BELOW

EQUIPMENT DESCRIPTIONThis equipment is a revolving field, alternating cur-rent generator set. It is powered by a gaseous fueled engine operating at 18

ENGINE PROTECTIVE DEVICESThe standby generator may be required to operate for long periods of time without an operator on hand to monitor such engine

FUEL SYSTEMFUEL REQUIREMENTSThe standby generator may be equipped with one of the following fuel systems:• Natural gas fuel system• Propane vapor (P